R928045227造紙工業木原漿過濾器濾芯

R928045240

R928045243

R928045244

R928045246

R928045247

R928045249

R928045225

R928045226

。紅色箭頭在操作把手點值班

chamber(s).

室（的）。

2. Open off-duty vent plug(s). Do not thread out

2。打開下崗排氣塞（S）。不倒帶

completely.

完全的。

3. Open the pressure equalizing (fi ll line) valve slowly to

3。打開均壓（FI將線）閥慢慢

admit fl uid to the off-duty chamber(s).

承認流體對下崗室（的）。

4. When fl uid is discharged from the off-duty vent

4。當流體從下崗孔排出

plug(s), close and tighten.

塞（S），關閉并擰緊。

5. Turn the “T” handle, on the center valve section,

5。把“T”處理，在中心閥部分，

counter-clockwise 5 turns.

逆時針轉5。

6. Depress the operating handle to unseat the seal

6。降低操作手柄的罷免密封

shoes, then rotate 180° and return handle upward

鞋，然后旋轉180°回手柄向上

into the opposite slot.

在相對的槽。

7. Turn the “T” handle fully clockwise and hand tighten

7。把“T”手柄順時針和手?jǐn)Q緊

only. This will seat the shoes.

只有。這座鞋。

8. Close the pressure equalizing valve.

8。關閉壓力平衡閥。

9. Red arrow now points to the new on-duty

9。紅色箭頭現在點值班新

chamber(s).

室（的）。

10. Open the new off-duty vent plug(s).

10。打開新的下崗排氣塞（S）。

11. Remove the new off-duty chamber cover(s) by

11。移除新下崗室蓋（S）的

rotating counter-clockwise.

逆時針旋轉。

12. Remove the new off-duty drain plugs and drain

12。移除新下崗排水塞和排水

chambers to desired level.

室所需的水平。

13. Follow steps 3 - 7 on opposite page.

13。步驟3 - 7頁。

14. Close and tighten the vent plug(s).

14。關閉并擰緊排氣塞（S）。

Warning: You should not rotate the handle

警告：你不應該轉動手柄

until you equalize the pressure.

直到你的平衡壓力。